Collision Eth0 Eth1

Postby SerjiOK » Mon Jan 26, 2009 9:00 am

Здравствуйте!
Знатоки подскажите 10% коллизий это нормально?
----- : Interfaces : -----


----- ifconfig -----
eth0 Link encap:Ethernet HWaddr 00:60:08:79:73:83
inet addr:255.255.255.255 Bcast:255.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1030664 errors:0 dropped:0 overruns:0 frame:0
TX packets:788926 errors:0 dropped:0 overruns:0 carrier:2
collisions:66799 Interrupt:10 Base address:0x300
eth1 Link encap:Ethernet HWaddr 00:60:08:79:75:89
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:789086 errors:0 dropped:0 overruns:0 frame:0
TX packets:994142 errors:0 dropped:0 overruns:0 carrier:0
collisions:10709 Interrupt:5 Base address:0x310
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:38 errors:0 dropped:0 overruns:0 frame:0
TX packets:38 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
ppp0 Link encap:Point-Point Protocol
inet addr:10.4.0.255 P-t-P:212.115.225.26 Mask:255.0.0.0
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:994195 errors:0 dropped:0 overruns:0 frame:0
TX packets:788925 errors:0 dropped:0 overruns:0 carrier:0
collisions:0


----- : Routing : -----


----- route -n -----
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
255.255.255.255 0.0.0.0 255.255.255.255 UH 0 0 0 eth1
212.115.225.26 0.0.0.0 255.255.255.255 UH 0 0 3 ppp0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 2 eth1
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 4 lo
0.0.0.0 212.115.225.26 0.0.0.0 UG 0 0 2590 ppp0
User avatar
SerjiOK
Newbie
 
Posts: 1
Joined: Mon Jan 26, 2009 8:39 am

Return to Russkij - Russian

Who is online

Users browsing this forum: No registered users and 1 guest

cron