Sorry I just noticed that I posted in 0.3.x, it should have been in 0.4.x.
I am using Freesco 0.4.0 with the pcmcia-3.1.34-lightning package.
My problem is a D-link DFE-680TX that is supported by the package has far as I can see. I insert the card and get two beeps, 1st one that its been inserted (good beep), 2nd one a (bad beep) client drive not loaded. I have a old Linksys 16-bit that works no problems. My laptop is a Dell Inspiron 3800.
Intel ISA/PCI/CardBus PCIC probe:
TI 1225 rev 01 PCI-to-CardBus at slot 00:03, mem 0x68000000
host opts : [ring] [serial pci & irq] [pci irq 11] [lat 32/32] [bus 32/34]
host opts : [ring] [serial pci & irq] [pci irq 11] [lat 32/32] [bus 35/37]
ISA irqs (scanned) = 3,4,7,9,10 PCI status changes
cs:cb_alloc(bus 35): vendor 0x13d1 device 0xab02
00:00.0 Host bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX Host bridge (rev 03)
00:01.0 PCI bridge: Intel Corporation 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge (rev 03)
00:03.0 CardBus bridge: Texas Instruments PCI1225 (rev 01)
00:03.1 CardBus bridge: Texas Instruments PCI1225 (rev 01)
00:07.0 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 02)
00:07.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
00:07.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01)
00:07.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 03)
00:08.0 Multimedia audio controller: ESS Technology ES1983S Maestro-3i PCI Audio Accelerator (rev 10)
00:08.1 Communication controller: ESS Technology ES1983S Maestro-3i PCI Modem Accelerator (rev 10)
01:00.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M AGP 2x (rev 64)
23:00.0 Abocom Systems Inc. ADMtek Centaur-C rev 17 [D-Link DFE-680TX] CardBus Fast Ethernet Adapter
product info: "D-Link", "DFE-680TX", "V1.0", ""
manfid: 0x13d1, 0xab02
function: 6 (network)
I have searched everywhere to see if I missed something, but nothing....
I hope someone can help me figure this out.......