by Lightning » Sat Feb 07, 2009 3:11 am
There is a bug in the move2hd command that causes the "overwrite" option to malfunction. The solution to this problem is to use this commands on the running hard drive system before shutting the system down and booting the 0.4.1 floppy
- Code: Select all
:>/boot/v_0_3_x
sync
sync
SPECIAL NOTE: For anyone installing cleanly or a new system this patch is NOT needed. It ONLY applies when trying to "overwrite" an existing 0.4.x hard drive install on a FAT hard drive and does NOT apply to ext2 installs.
If you are afraid that you might make a mistake. The chances are high that you will never learn anything.